Standard finder

Plastics piping systems - Glass-reinforced plastics (GRP) components - Determination of the amounts of constituents (ISO 7510:2017)

Fibre-reinforced plastic composites - Determination of compressive properties in the in-plane direction (ISO 14126:2023)

Textile-glass-reinforced plastics - Prepregs, moulding compounds and laminates - Determination of the textile-glass and mineral-filler content using calcination methods (ISO 1172:2023)

Plastics - Determination of tensile properties - Part 4: Test conditions for isotropic and orthotropic fibre-reinforced plastic composites (ISO 527-4:2023)

Plastic materials. Shear test method by means of tension-compression on cruciform specimen

Plastics - Determination of tensile properties - Part 5: Test conditions for unidirectional fibre-reinforced plastic composites (ISO 527-5:2021)

Plastics - Acquisition and presentation of comparable single-point data - Part 2: Long-fibre-reinforced plastics (ISO 10350-2:2020)

Fibre-reinforced plastics - Moulding compounds and prepregs - Determination of mass per unit area and fibre mass per unit area (ISO 10352:2020)

Fibre-reinforced plastic composites - Shear test method using a shear frame for the determination of the in-plane shear stress/shear strain response and shear modulus (ISO 20337:2018)

Continuous-fibre-reinforced plastic composites - Pultruded unidirectional rods - Determination of tensile properties in parallel to the fibre direction

Glass reinforced plastics - Determination of indentation hardness by means of a Barcol hardness tester

Plastics piping systems - Glass-reinforced thermosetting plastics (GRP) based on unsaturated polyester resin (UP) - Guidance for the structural analysis of buried GRP-UP pipelines (Endorsed by AENOR in May of 2014.)

Plastics piping systems for water supply and for buried and above-ground drainage and sewerage under pressure - Unplasticized poly(vinyl chloride) (PVC-U) - Part 7: Guidance for the assessment of conformity (Endorsed by AENOR in May of 2014.)

Plastics piping systems for water supply or drainage and sewerage - Glass-reinforced thermosetting plastics (GRP) based on unsaturated polyester resin (UP) - Recommended practice for installation (Endorsed by AENOR in May of 2014.)

Fibre-reinforced plastic composites - Declaration of raw material characteristics - Part 5: Specific requirements for core materials

Fibre-reinforced plastic composites - Declaration of raw material characteristics - Part 4: Specific requirements for fabrics

Fibre-reinforced plastic composites - Declaration of raw material characteristics - Part 2: Specific requirements for resin, curing systems, additives and modifiers

Fibre-reinforced plastic composites - Declaration of raw material characteristics - Part 1: General requirements

Fibre-reinforced plastic composites - Declaration of raw material characteristics - Part 3: Specific requirements for fibre

Plastics. Determination of chemical resistance of glass reinforced plastics.

Fibre-reinforced plastics. Methods of producing test plates. Part 8: Compression moulding of SMC and BMC

Fibre-reinforced plastics. Methods of producing test plates. Part 10: Injection moulding of BMC and other long-fibre moulding compounds. General principles and moulding of multipurpose test specimens

Fibre-reinforced plastics. Methods of producing test plates. Part 9: Moulding of GMT/STC

Fibre-reinforced plastics. Methods of producing test plates. Part 11: Injection moulding of BMC and other long-fibre moulding compounds. Small plates